Assign Ring Plan Time - Samsung OfficeServ 500 Programming Manual

Hide thumbs Also See for OfficeServ 500:
Table of Contents

Advertisement

[507] ASSIGN RING PLAN TIME

Use this MMC to program Ring Plans time settings. Ring Plans provide six separate
ringing destinations based on day of the week and time of day. The start time within a plan
is the time the system will switch from one ringing destination to the next. The end time is
the time the system will switch from that plan to the previous plan.
A RPO(Ring Plan Override) key is not needed as the system will switch automatically;
however, it is helpful to have a dedicated button so the status can be manually changed if
needed. If a ring plan has no time entry the ring plan defaults to ring plan 1. The ring plans
correlate with all MMC's that program ring or termination destinations and station and
trunk COS.
Use the following example of assigning Ring Plans:
RING PLAN
(MON: 1)
(MON: 2)
(MON: 3)
(MON: 4)
(MON: 5)
(MON: 6)
Using a 24 hour clock in the example above notice that the END time is within the same 24
hour period. The system will stay in the last active Ring Plan from the previous day until
the end time which is 23:59. Monday starts the Ring Plan 1 at 00:00. The system will stay
Ring Plan 1 until 08:00 and will stay in Ring Plan 2 until Ring Plan 3 starts. As each ring
Plan start it will override the previous Ring Plan.
If a Ring Plan ends and there are no additional Ring Plans the system will default to the
Ring Plan with time that extends past the expired ring plan time.
CONDITIONS
When using a Samsung built-in Voice Mail Card that only has day/night mode, the
day/night must be set for each RING PLAN at 'MMC 758 VM DAY/NIGHT'.
Ring Plans must be programmed in sequence. IE. RP 1, 2, 3, 4 etc.
A Ring Plan cannot be omitted. IE. RP 1, 2, 5 etc.
A higher numbered Ring Plan cannot have a START time before a lower numbered
Ring Plan
Ring Plan 1
Ring Plan 1 is the default Ring Plan of each day. If no Ring Plan destination is
input the operator group is the default destination.
© SAMSUNG Electronics Co., Ltd.
OfficeServ 500 Programming Guide
Start Time
ST: 0000
ST: 0800
ST: 1000
ST: 1200
ST: 1300
ST: 1400
End Time
END: 23:59
END: 2200
END: 2000
END: 1800
END: 1600
END: 1500
2-177

Advertisement

Table of Contents
loading

Table of Contents