Voip Access Code - Samsung OfficeServ 500 Programming Manual

[832] VOIP ACCESS CODE

Provides a means to apply the Internet Protocol(IP) address to the VoIP gateway.
This MMC also assigns the number of channels that can be used for IP faxes.
TABLE(00~62): Outbound or Inbound table use for specific access codes. Usually when
the MCP2 card is used as a VoIP gateway the Outbound table is used. The Inbound table is
used to determine the number of digits to receive before processing the call. Each table has
63 entries(00~62).
No Option
0 ACCESS DGT
1 DGT LENGTH
2 DEL.LENGTH
3 INSERT DGT
4 IP TABLE 1
5 IP START
6 GK USE
CONDITIONS
NONE
© SAMSUNG Electronics Co., Ltd.
This is the access code that is used once the VoIP gateway is
accessed; this directs a call based on the routing tables used.
An access code table then references an access code and correlates an
IP address to the access code for routing. A maximum of 8 digits are
available.
This field requests the number of digits that are expected to be received
to make up the whole access code.
This is the number of digits to delete after receiving the access code.
If no digits are deleted the access code will be sent as part of the call to
the destination to continue routing at the far end destination.
This is the digit(s) to insert for routing at the destination. This can be
used when different numbering plans exist or if a dial 9 access is
needed to be inserted in the dialed digits.
This is the first table referenced for routing the access code to an IP
address. The system has 64 IP tables(00~63) with 16 entries(00~15) in
each table. See MMC 833.
This entry indicates where in a table to start looking for an IP code to
associate with the access code. This can be used to manage where to
start looking for an IP address in high traffic VoIP gateway applications.
Example: If IP address routing to the desired destination is known to be
in the last 7 entries of a table the IP START location would be 8.
IP address searching would start at entry 8.
This parameter determines whether a H.323 Gatekeeper will be utilized
to establish this connection.
OfficeServ 500 Programming Guide
Description
2-365