Samsung OfficeServ 500 Programming Manual page 322

CHAPTER 2. Ошибка! Стиль не определен.
Message
TRANSLATION
TABLE
BUSY DESTINATION
NO ANSWER
DESTINATION
NO ACTION
DESTINATION
INVALID
DESTINATION
NOTE ABOUT
TRUNK SIGNALING
CONDITIONS
NONE
DEFAULT DATA
RETRY COUNT: 3
BUSY DESTINATION: 500
NO ANSWER DESTINATION: 500
NO ACTION DESTINATION: 500
INVALID DESTINATION: 500
PROGRAM BUTTONS
A Used to enter P on destination field
2-280
Determines what translation table this plan will use.(see MMC 732 Auto
Attendant Trans Table) The default value is same number of plan number.
Determines the destination for the call if the selected destination is busy.
This can be another station, station group or plan. Plans are entered by
pressing A button plus two digits 01-12.
Determines the destination for the call if the selected destination does not
answer. This can be another station, station group or plan. Plans are
entered by pressing A button plus two digits 01-12.
Determines the destination for the call if the caller makes no response(this
is also the destination for rotary dial callers). This can be another station,
station group or plan. Plans are entered by pressing A button plus two
digits 01-12.
Determines the destination for the call if the caller dials invalid digits after
the retry counter has expired. This destination can be another station,
station group or plan. Plans are entered by pressing A button plus two
digits 01-12.
UCD is designed to hold a call until an agent is available. It is therefore
essential that a customer gets a disconnect from the Trunk Line when a
caller hangs up. If not the call may be held in the UCD loop until
answered. This could be a long time, and when an agent finally does
answer there would be no one there.
Description
© SAMSUNG Electronics Co., Ltd.
(Continued)