Assign Trunk Group - Samsung OfficeServ 500 Programming Manual

CHAPTER 2. Ошибка! Стиль не определен.

[603] ASSIGN TRUNK GROUP

Allows the assignment of trunks to a specific trunk group or to several trunk groups. This is
very useful in the programming of LCR when more than one trunk is to be in several
dialling plans. There are two different modes of operation:(1) sequential and(2) distribute.
There are 30 programmable trunk groups with up to 99 members per group.
ASSIGN TRUNK GROUP
One trunk can appear in more than one trunk group. If necessary, delete the trunk
member from other groups to prevent accidental access.
CONDITIONS
NONE
DEFAULT DATA
ALL LOOP/ISDN TRUNKS: 9
ALL TIE TRUNKS: 801
ALL VOIP NETWORKING TRUNKS: 803
ALL VOIP H.323 TRUNKS: 804
ALL VOIP SIP TRUNKS: 805
ACTION
1) Press Transfer button and enter 603.
Display shows:
2) Enter in valid trunk group.(e.g., 9)
OR
Press Volume button to make selection and press
Right Soft button to advance cursor.
3) Press Right Soft button to change mode.
OR
Press Volume button to change mode to member.
4) Press Right Soft button to move cursor to number
of member and enter valid member number
(e.g., 05) via dial keypad.
OR
Press Volume button to make selection and press
Right Soft button to move cursor.
2-194
DISPLAY
[9] TRK GROUP
MODE:SEQUENTIAL
[9] TRK GROUP
MODE:SEQUENTIAL
[9] TRK GROUP
MEMBER 01:NONE
[9] TRK GROUP
MEMBER 05:NONE
© SAMSUNG Electronics Co., Ltd.