Pc Programming; Voice Mail/Auto Attendant - Samsung OfficeServ500 Installation Manual

PC Programming

The system can be programmed via a personal computer (PC), running the PCMMC program.
The PC can be connected either to the LAN port on the front panel of the MCP2 card (see
ure 4-1 in Chapter 4) or to a serial interface (SIO) connector on the IOM card
recommended that the LAN option is used.
To connect to an SIO port, use an RS232C cable with connections as shown in
the PC needs to be more than 3m (10 ft) away from the KSU, use shielded computer cable. At-
tach a male DB9 connector to the SIO end of the cable and a connector that meets the require-
ments of the PC to the other end. This cable must not exceed 300 feet.
For information on programming the ports, refer to MMC 804 in the Samsung Combined Sys-
tems Programming Manual.

Voice Mail/Auto Attendant

The system provides special programming and hardware for use with a customer-provided voice
mail/auto attendant (VM/AA) system. All single line stations on the SLI and 8SLI cards provide a
disconnect signal required for VM/AA operation.
Use one pair twisted #24 AWG (0.5mm) or #26 AWG (0.4mm) jumper wire to cross-connect SLI
circuits to the VM/AA system. For information on programming these ports, refer to MMCs 207,
601 and 726 in the Samsung Combined Systems Programming Manual. See also the Samsung
Single Line Telephone User Guide for feature codes and instructions.
NOTE: To install and configure the Samsung Cadence or SVMi-8 Voice Mail / Auto
Attendant system, see Chapter 12.
8-3
Fig-
(Figure 8-4). It is
Figure 8–6. If