Customer On/Off Per Station - Samsung OfficeServ 500 Programming Manual
Hide thumbs
Also See for OfficeServ 500:
- User instruction (359 pages) ,
- User manual (156 pages) ,
- General description manual (124 pages)
Table of Contents
Advertisement
CHAPTER 2. Ошибка! Стиль не определен.
[300] CUSTOMER ON/OFF PER STATION
Allows the following features to be enabled on a per-station basis.
No
Option
00
ACCESS DIAL
01
MICROPHONE
02
OFF-HOOK RING
03
SMDR PRINT
04
TGR ADV.TONE
05
VMAA FORWARD
07
NGT PASSCODE
08
INTRCOM SMDR
09
FWD DLY USE
11
FORWARD OVRD
12
RECL TO OPER
13
SLT LP OPEN
15
CID TO SLT
2-74
Default
ON
Determines whether a user can select a trunk or trunk
group by dialling its directory number(DN).
This selection should be turned to off when using LCR.
ON
Allows all 12 and 24 button phones to be used in the
speakerphone mode.
ON
Will allow a short burst of ring tone to indicate another call.
ON
When the station is set for no Trunk Line calls to and
from this station, the station will not print on SMDR.
This includes transferred calls or calls picked up from
hold or park.
ON
When this feature is set to ON, a warning tone will be
heard each time LCR advances to the next route.
ON
This feature selects whether Trunk Line calls can be
forwarded to voice mail. When ON, Permits forward to
voice mail. When OFF, No forward to voice mail.
ON
When ON, the steps verifying the RING PLAN
passcode will be added in Ring Plan change.
OFF
When the station is set to OFF, the station will not print
intercom calls on SMDR.
OFF
When the station is set to ON, if the station has no
answer forward number without no answer forward set
then a call both ringing original extension and no
answer forward number when a incoming call is
directed to the station and the station does not answer
until no answer forward time.
OFF
When the station is set to ON, if the station call to
forwarded station, the call will not forward.
OFF
When the station is set to ON, if the station transfer a
call and the destination doesn't answer, the call will be
recall to operator instead of the station.
OFF
When the normal phone is set to ON, if the station
receives real disconnect signal instead of busy tone or
error tone. In case of VMAA ports or DATA RING ports
are not reference this option, this type SLI ports are
always receives real disconnect signal.
OFF
When RCM2 card is installed and this option is set to
ON, the system will provide the CID signal to the SLT.
Description
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
