Samsung OfficeServ 500 Programming Manual page 281

Option
1: XXX, 2: XXX,
3: XXX, 4: XXX,
5: XXX, 6: XXX
CW
MC
DC
NAME
CONDITIONS
If an E & M line is designated as FOLLOW DID TRANS at 'MMC 416 ASSIGN E &
M/DID RINGDOWN', calls are terminated according to the station direct dial translation
table of 'MMC 714 DID NUMBER AND NAME TRANSLATION'.
DEFAULT DATA
INDEX DIGIT
001 2***
002 3***
003 5***
004 8***
© SAMSUNG Electronics Co., Ltd.
Ring plan and destination during each ring plan. The destination can be a
station, station group, trunk or trunk group. If trunk or trunk group is
selected the trunks must be programmed as E & M trunks to allow the
received digits to be re-sent on the facility(s). This is referred to as DID
Repeat digits over tie line.
An entry of the character 'B' means to repeat the received digits.
'A' setting indicates AUTO ANSWER, and 'D' setting indicates DISA.
Call waiting Yes/No . Allow a second DID call to be received
The number of maximum call count. When this sets 99, this feature will not
works. When this sets 0, if a call comes that matched DID digits and DGT field
then the system will be reject call. When this sets between 1 to 98, if a call
comes that matched DID digits and DGT field then the system counts same DID
digits call, and in case of the count is same or higher than this value, the system
sends busy signal to caller.
The number of digits to delete. This is useful with Tandem switching,
mixed numbering plans and DID Repeat digits over tie line. Maximum
number of digits that can be deleted is 16.
Input up to 11 characters to identify call.
Refer to 'MMC [104] STATION NAME' for descriptions on INPUT
CHARACTERS.
MOH PRI 1-6
NONE NO B
NONE NO B
NONE NO B
NONE NO B
OfficeServ 500 Programming Guide
Description
CW MC DC
N 99 0
N 99 0
N 99 0
N 99 0
(Continued)
NAME
NONE
NONE
NONE
NONE
2-239