Pf Motor Endurance Menu - MUTOH ValueJet 1304 Service Manual

VJ-1304 Maintenance Manual

5.13.2 PF Motor Endurance Menu

This menu performs endurance running for the PF motor.
You can drive the PF motor according to your desired settings. The available settings are shown below.
Table 5-20 Set Items in PF Motor Endurance Menu
Set item
Media feed amount
Number of endurance
running cycles
TIP
• The following table shows the motor moving parameters to media feed amount.
Speed
Acceleration
Deceleration
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If the
number of cycles exceeds the maximum value, the counter is reset to 0.
CS9050, CS9150
Contents
Set the media feed amount
per endurance running
cycle
Set the number of
endurance running cycles
[Enter] key
[Enter] key
[Enter] or [Cancel] key
5-69
Set value
0.1 to 100 Unit: mm
-1 to 10000
35CPS
0.1G
0.1G
Media feed amount
Endurance count
Performing endurance
5 Self-Diagnosis Mode
Remark
Rev.-01