How To Update Parameters; How To Update The Capping Position Parameter - MUTOH Rockhopper 38 Maintenance Manual

5.7.2 How to Update Parameters.

This procedure will update adjustment parameters.
Note:
The actual writing to flash memory is done when diagnostics are completed or power is
switched off.
Press [ENTER] to input the adjustment parameter.
Press [BACK] to return to "Param: Update"

5.7.3 How to Update the Capping Position Parameter

This procedure will update the capping position parameter.
If [Back] is pressed instead of the second [ENTER], a message that the parameter is not updated will appear
and the display will move to "UPDATE: Home".
Rockhopper 38 – Maintenance Manual
140
AP-74038, Rev. 1.1, 25/01/05