Replacing Cutter - MUTOH XpertJet XPJ-1641SR Training Manual

11. User Maintenance

11.12. Replacing Cutter (1/2)

Replacing consumable parts
Replacing Cutter
Replacing period:
・ When the media is not cut smoothly
When the cut surface is feathered, etc
・
Preparation:
・ Cutter replacement blade
・ Do not push the knob of cutter or release suddenly.
Because there is a spring under the cutter, the cutter can jump out.
・ Do not touch the cutter blade.
It may cause injury.
1. Step (1/3)
[1] Put the printer into the CR maintenance mode.
[2] Open the front cover.
[3]
[4]
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.132)
Open the maintenance cover on the left side.
Press the cutter cap lightly, turn Cutter holder in
the direction as illustrated below.
Do not push down the cutter cap.
It may damage the part.
Replacing Cutter
1. Step (2/3)
[5]
[6]
[7]
[5]
[6] Close the front cover.
Page. 117
To Table of Contents
cf. Operation Manual(Rev.01-p.133)
Remove the Cutter.
Used Cutter should be put in a plastic bag, etc,
and dispose of it in compliance with local
ordinance and instructions of local authorities.
Attach a new cutter.
Press the cutter cap lightly, return Cutter holder to
its initial position.
Close the maintenance cover.
CONFIDENTIAL