Fitting The Source Enclosure To The Instrument - Waters Xevo G2-XS QTof Overview And Maintenance Manual

Figure 7–1: Source enclosure mounted on instrument
Cable storage positions
Supporting stud
Source enclosure
7. Store the cables neatly by plugging them into the cable-storage positions on the rear of the
source enclosure.

7.5.2 Fitting the source enclosure to the instrument

Required materials
Chemical-resistant, powder-free gloves
To fit the source enclosure to the instrument:
Warning:
To avoid personal contamination with biologically hazardous, toxic, and corrosive
materials, wear chemical-resistant, powder-free gloves when performing this procedure.
Warning:
enclosure open if one or both of these conditions apply:
• An ESI probe is fitted (the probe's tip is sharp).
• A corona pin is fitted (the pin's tip is sharp).
To avoid puncture wounds, take great care while working with the source
March 31, 2021, 715004496 Ver. 04 (previously released as Rev. D)
Page 92