Waters Xevo G2-XS QTof Overview And Maintenance Manual page 225

Figure 7–134: Connecting the LockSpray selector valve and left-hand side of the
flow sensor
A
A
B
B
C
C
B
A
Wat ers
A
Flow sensor
Figure 7–135: Long, finger-tight PEEK nut and 1/32-inch PEEK ferrule:
Figure 7–136: 1/32-inch, 6-40 Valco compression fitting assembly
11. Using a 1/32-inch Valco component fitting assembly, connect the red, 1/32-inch, 60-mm
PEEK tubing between the flow sensor and the grounded union, where you use a use a
short, finger-tight nut and 1/32-inch ferrule.
Important:
The narrower 1/32-inch tubing can slip out of the port. After tightening the
fitting, gently tug the tubing to ensure that it is secure in the port.
March 31, 2021, 715004496 Ver. 04 (previously released as Rev. D)
C
C
B
Page 225