Plumbing The Intellistart Fluidics Lockspray System - Waters Xevo G2-XS QTof Overview And Maintenance Manual

3. Unscrew and remove the PEEK thumbscrews and tubes from between the flow sensor and
the grounded union, if these are used.
4. Close the access doors to the IntelliStart Fluidics system.
Warning:
corrosive materials, dispose of all waste materials according to local environmental
regulations.
5. Dispose of the tubes and fittings in accordance with local environmental regulations.

7.34.3 Plumbing the IntelliStart Fluidics LockSpray system

This section explains how to plumb the LockSpray system.
Requirement:
Figure 7–128: Tubing schematic for the LockSpray system:
A
B
C
(Optional) From external reference bottle
(Optional) Flow sensor
From wash bottle
To reference probe
(Optional) Grounded union
LockSpray selector valve
From pump
To avoid spreading contamination with biologically hazardous, toxic, and
Finger-tighten all PEEK fittings.
2 1
3 7 6
4 5
March 31, 2021, 715004496 Ver. 04 (previously released as Rev. D)
Page 220