B External Connections; Mass Spectrometer External Wiring And Vacuum Connections - Waters Xevo G2-XS QTof Overview And Maintenance Manual

Hide thumbs Also See for Xevo G2-XS QTof:
Table of Contents

Advertisement

B External Connections

This appendix describes the mass spectrometer's external connections.
Warning:
and the supplied harness to lift it.
Notice:
• Contact Waters Technical Service before moving the instrument.
• If you must transport the instrument, or remove it from service, contact Waters
Technical Service for recommended cleaning, flushing, and packaging procedures.
B.1 Mass spectrometer external wiring and vacuum
connections
The instrument's rear panel connectors are shown below.
Note:
The two switches above the roughing pump connector are for use by Waters service
engineers. Keep them in the "up" position unless instructed otherwise by a Waters service
engineer.
The mass spectrometer is heavy. To avoid injury, use suitable machinery
To avoid damaging the mass spectrometer, observe the following precautions:
March 31, 2021, 715004496 Ver. 04 (previously released as Rev. D)
Page 256

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents