Waters Xevo G2-XS QTof Overview And Maintenance Manual page 116

Figure 7–20: Cone extraction tool location
Combined 2.5-mm hex wrench and cone extraction tool
2. Slide the collar to the end of the tool.
Figure 7–21: Cone extraction tool
Collar
3. Insert the collar in the sample cone.
Figure 7–22: Inserting the cone extraction tool
Insert the collar
Notice:
To avoid damaging the sampling cone, which is fragile, do not place it
on its tip. Always place it on its flanged base.
4. Rotate and lift the tool and collar to remove the sample cone from the cone gas nozzle.
March 31, 2021, 715004496 Ver. 04 (previously released as Rev. D)
Page 116