Removing 2.5-Inch Hdd/Ssd Modules - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state disk (SSD)
Figure 125: Installing the 2.5-inch HDD/SSD module
▶ Insert the HDD/SSD module into a drive bay and carefully push back as far
as it will go (1).
▶ Close the locking lever to lock the HDD/SSD module in place (2).
▶ When using a RAID array, add the additional HDD/SSD to the RAID array.
Configuring the RAID array, see the documentation of the RAID
controller, used in your configuration, see
on page
Concluding steps
▶ If applicable,
"Reassembling" on page
7.5.3

Removing 2.5-inch HDD/SSD modules

Customer Replaceable
Unit (CRU)
Tools: Tool-less
216
28.
Upgrade and Maintenance Manual
"Documentation overview"
66.
Hardware: 5 minutes
TX1330 M4