Ricoh V-C3 Technical Training Manual page 111

! SP5045 001 can change the counter type for the
display. If you want to change this, change it
before you make the SMC report.
" The default for the counter is 'developments'.
! Then you can print an SMC report. Keep it in a
safe location.
Slide 111
# In the V-C2, you cannot change this setting back to 'developments' if you change
it to 'pages', unless you use an SSP mode.
# For the V-C3, you can change it again at any time.
Set the Counter Type
V-C3 series service manual, Installation, Copier, Installation,
111
V-C3 Training
Counter Display Setting