Advertisement
Drum and Cleaning Blade Replacement
! Coat the new drum with Lubricant Powder (B1329700)
before you install it.
" The Lubricant Powder (B1329700) is specially designed for
this machine.
! Do not use the previous Setting Powder (54429101) when
you work on this machine.
" If you use Setting Powder (54429101) on this machine, you
will cause damage to the drum charge roller and cause
problems with image quality.
! Do not use the yellow toner from this machine as a
lubricant, because it contains carrier, and this will damage
the drum and ITB.
! The yellow toner for the V-C1 is required for the
maintenance of this model, when the lubricant brush roller
in the PCU is replaced.
Slide 360
# The lubricant powder B1329700 is made from zinc stearate. The old setting
powder (54429101) has a completely different composition.
# The lubricant powder is applied with a bag that contains the powder. This bag
can get covered with toner. But this is not a problem.
# This new lubricant powder is also used when you replace the image transfer belt
(ITB).
# The V-C1 series was not sold in some areas, but the toner is available as a
service part (see below).
# Part numbers of required lubricants
$ G104 YELLOW TONER (D0159500) – this is the V-C1 yellow toner
G104 yellow toner – this is just the name. It has nothing to do with a
model code G104!
$ ZINC STEARATE (D0159501) – this lubricant powder is for the PCU
lubricant brush rollers
$ ZINC STEARATE (B1329700) – this is for the other procedures that require
lubricant powder.
Applying Lubricant Powder
V-C3 series field service manual, Replacement and
Adjustment, PCU, Separating Drum/Cleaning Unit /
360
V-C3 Training
Removing the OPC Drum
Advertisement
