Ricoh V-C3 Technical Training Manual page 52

Lower Slot – Important Note (1)
! VM card applications such as App 2 Me must be halted if
you need to remove the VM card.
" Normally, you need to remove the VM card at these times:
» To update the firmware
» To back up the NVRAM
» To install the browser unit or the HDD encryption unit.
» To update the App 2 Me application firmware
! To halt the VM card applications, do the following steps:
" 1. Push the "User/Tools" key.
» If an administrator setting is registered for the machine, step 2
" 2.Push the "Login/Logout" key.
" 3.Login with the administrator user name and password.
" 4.Touch "Extended Feature Settings" twice on the LCD.
" 5. Touch each application until the status changes to
"Stop".
» It is necessary to stop each application that is running before
" 6. Turn off the machine. And then remove the VM Card.
Slide 52
# You have to remove the VM card to execute a service procedure, such as those
listed on the slide.
# After the firmware update, or whatever, then you have to enable App 2 Me and
the other extended features again. To do this, see the next slide:
and 3 are required. Otherwise, skip to step 4.
you remove the VM card.
52
V-C3 Training