Advertisement
Initializing Developer and Toner
! Do SP 3811 001.
" This sends toner to the sub hopper of the PCU, covers the
drum with a layer of toner (to prevent the cleaning blades
from flipping, or damaging the drums), initializes the TD
sensor, and does process control. It takes about 4.5
minutes.
" If 'Failed' appears immediately after you start, the machine is
not warmed up. Wait 2 minutes then do SP 3811 001 again.
! Then check that the initialization was done correctly. To do
this, use SP 3812.
" If the display is not '1111', see 'Special Procedures' in the
Troubleshooting section of the manual.
! Then check that the initial process control was done
correctly. To do this, use SP 3821 001.
" If the display is not '10101010', see 'Special Procedures' in
the Troubleshooting section of the manual.
Slide 103
# Forced MUSIC is done later with a user tool.
3. SP Modes
103
V-C3 Training
Advertisement
