Advertisement
Bottom Plate Lift Sensor
(in this area)
! The bottom plate lift motor lifts the bottom plate at the following
times:
" Just after the original set sensor detects an original
" When some originals have been fed, and the top of the stack
needs lifting
Slide 263
# The timing for the bottom plate motor to lift the bottom plate can be changed with
SP 6900. The default is when an original is detected (as shown on the slide).
However, this can be changed to after the Start key is pressed.
# The bottom plate sensor determines whether the plate needs lifting.
$ When an original is placed on the original tray: The original set sensor
switches on, the pick-up roller drops, and the sensor (on the pick-up roller
assembly) switches off. Then, the motor lifts the lever, raising the bottom
plate.
$ When the bottom plate reaches the correct feed position: The sensor
switches off and the motor stops.
$ During the job, when the top of the stack becomes too low: When the pick-
up roller drops low enough to switch the sensor on again, the motor
switches on again to raise the stack to the correct feed position.
Bottom Plate Lift
263
Bottom Plate
Lift Motor
Lever
V-C3 Training
Advertisement
