Ricoh V-C3 Technical Training Manual page 74

! We do not remove the PCU from the machine, so we do not
need the PCU stand.
! First, we install each developer bottle on a port at the front
of each PCU.
! Then we remove the seals from each bottle, and make sure
that the developer can flow freely from each bottle.
! Then, we use SP mode to transfer the developer from the
bottles to the PCUs.
" The SP installs all 4 developers at once.
" There are SPs to install individual colors also, but at
installation, we can do them all at once.
! Then we check that the developer was installed correctly.
" There is an SP to check for errors.
" Also, we check visually to see if developer remains in the
bottle.
Slide 74
# This slide shows the steps in outline. The next few slides explain these steps in
more detail.
Installing Developer
Overview
74
V-C3 Training