Ricoh V-C3 Technical Training Manual page 85

! CLOSE THE FRONT DOOR, THEN TURN THE MACHINE
POWER ON.
! Wait for the machine to beep twice.
" This indicates that the fusing unit is ready.
" If you do not wait for the beeps, SP3814 (fill the PCUs with
! Do SP 3814-1.
" This moves the developer from the bottles to the
" It takes about 3 minutes.
" When "Completed" appears on the display, press "Exit".
! Do SP3815.
" This checks that SP 3814-1 was executed correctly.
" If all is correct, you should see "1111" on the display.
" If another number is shown, see the service manual.
Slide 85
CLOSE THE DOOR BEFORE YOU TURN THE POWER ON.
# This is required by the software.
# In other color products, we keep the door open to prevent initial process control.
# However, for this machine, it is different. How does the machine detect that it is
not time to start process control? At this time, the toner hopper has been
removed. The machine detects the absence of the electrical connection to the
toner hopper, and when it detects this, it does not start the initial process control.
Installing Developer
7. SP Mode
developer from the bottles) will fail.
development units.
» For example, if "1191" is displayed, this could mean that the
tape was not removed from the C bottle.
85
V-C3 Training