Advertisement
After Replacing the Hot Roller
! After replacement of the hot roller, the gap
between the fusing belt strippers and the fusing
belt may need to be adjusted.
! Make sure that the fusing unit is cool before you
start this procedure. If the fusing unit is still
warm when the adjustments are done, the gap
adjustment may not be within specification.
! Normally this procedure is not required. Do this
procedure only when:
" Paper has been frequently sticking to the fusing
belt and jamming the fusing unit.
" Streaking caused by fusing belt stripper pawls
has been occurring frequently in solid image
areas.
Slide 502
V-C3 field service manual, Removal and Adjustment, Fusing
Unit, Fusing Unit Rollers/Fusing Belt, Adjusting the Gap
Between Fusing Belt Strippers and Fusing Belt
502
V-C3 Training
Advertisement
