Ricoh V-C3 Technical Training Manual page 354

Slide 354
# The settings are on the SMC list, so that they can be input again in the case of
NVRAM failure.
Installing a New PCU - 1
354
! Remove the seal with the bar
codes. Use these numbers
later to input into the SP
mode
" SP 3010, 3011, 3012, or
3013, depending on the
PCU color.
" These are TD sensor
calibration characteristics.
" You can attach the seal to
a sheet of paper that
comes with the new PCU,
as a convenient means of
reference.
! The settings must be made if
you install a new
development unit or a new
PCU.
! Do these SPs before you do
the developer initialization.
V-C3 Training