Ricoh V-C3 Technical Training Manual page 153

Adjusting the Registration
Scale
Slide 153
# If you move the adjustment bracket, you cannot turn the small cross-shaped
bracket back 90 degrees at the end of the procedure, so do not try it.
Adjustment
Bracket
Cross-shaped
Bracket
153
! Loosen the screws.
! Remove the 'cross-
shaped' bracket, turn it
by 90 degrees, then
tighten the screw to
secure this bracket.
! Move the adjustment
bracket by the same
amount as the
registration shift.
" Use the scale to make
sure that you move the
bracket by the correct
amount.
" If the registration shift
was toward the front of
the machine, slide the
adjustment bracket to
the front.
! Then secure the
adjustment bracket
Service manual, section 1.13.2
V-C3 Training