Ricoh V-C3 Technical Training Manual page 376

Troubleshooting Note
! If the image density is too light, or if there is
toner scattering, or if the machine fails to release
the "Toner End" alert, this can be caused by one
of the following problems:
" Developer Filling (SP3814) was not successful.
" Developer Setup (SP3811) or TD sensor
initialization (SP3801) was not done or was not
done correctly after Developer Filling (SP3814).
" Developer Setup (SP3811) or TD sensor
initialization (SP3801) was done more than once.
! Please refer to "Special Procedures" in the
Troubleshooting section.
Slide 376
V-C3 service manual, Troubleshooting, Handling Errors,
376
V-C3 Training
Special Procedures