Ricoh V-C3 Technical Training Manual page 440

Side-to-side Registration
Slide 440
# 1. Open the tandem tray.
# 2. Remove the front cover of the right tray.
# 3. Loosen one screw.
# 4. Remove the other screw from the round hole and move it to the oval hole.
# 5. Look at the scale through the cut-out.
# 6. Shift the plate forward or back, check the position on the scale, and then
tighten both screws to set the plate at the new position.
Tandem Feed Tray
440
! Move the positioning
plate.
Move this
plate
Move this
screw
Loosen this
screw
V-C3 Training