Install Power Supplies and Tape Drives
Install Power Supplies and Tape Drives
Remove the Power Supply Filler
■
Insert a Power Supply into the Slot
■
Remove a Tape Drive Filler
■
Insert a Tape Drive Tray into the Slot
■
The power supply and tape drive can be added while the library is powered-on.
However, you must restart the library for it to recognize and account for the tape drive
if the library is not set to address all drive slots.
The instructions in this chapter have you remove the power supply or drive filler and
immediately insert the new power supply or tape drive in the open slot.
Figure 2–23 SL150 Library Rear View
Illustration Legend:
1 - Tape Drive Filler
2 - Power Supply Filler
2-24 StorageTek SL150 Modular Tape Library Guide
If you are not installing additional drives or power supplies,
Note:
skip to
"Cable the Library"
Do not operate the library with open tape drive or
Warning:
power supply slots.
on page 2-27.