Align the rear of the supply with the module slot. Push the supply fully into the
4.
module slot. Make sure the power supply is secured in the module slot.
Connect the power cord to the power supply receptacle.
5.
Verify that the OK indicator is active on the power supply. If not, continue to
6.
"Validate the Component
Remove a Power Supply Filler
You may need to remove a power supply filler if you are adding a new power supply
or replacing other CRUs. For instructions, see
page 2-25.
Install a Power Supply Filler
Position the filler with the spring fingers facing up.
1.
Insert the tabs on the right side of the filler into the power supply slot until the
2.
notch is near the module frame.
Seat the filler notch against the module frame edge.
3.
Push the left side of the filler into the power supply slot.
4.
Front Control Panel Removal and Replacement
The front control panel is located at the front of the base module.
Remove the Front Control Panel
■
Replace the Front Control Panel
■
Figure 10–3 Rear View of the Front Control Panel
Illustration Legend:
Installation".
The front control panel maintains the product serial
Caution:
number and customer settings. After installing the panel, you must
power-cycle the library before installing any other component.
Front Control Panel Removal and Replacement
"Remove the Power Supply Filler"
Replacing Components (CRUs & FRUs) 10-5
on