You can monitor library operations for component failures and operational problems.
Careful monitoring and prompt corrective action will minimize library downtime and
maximize the availability of your data.
View User and Host Activity
■
View the Library State
■
Configure Simple Network Management Protocol (SNMP)
■
Enable or Disable the Service Delivery Platform (SDP2)
■
Configure Email Notifications
■
View User and Host Activity
Use the activity log to display recent user and host activity.
Click Activity Log
1.
Click either the User Activity tab or Host Activity tab to view the library activity.
2.
View the Library State
The status bar at the top of the interface displays the library Health, which represents
the combined state of every component in the system.
Operative
■
Degraded
■
continue to function (such as a faulty drive).
Failed
■
robot).
Library LED Status Indicators
Library status indicators are located on the front control panel above the left cartridge
magazine and at the rear of the library on the robot customer replaceable unit [CRU].
— the library is fully operational.
— a device in the library has failed or is offline, but the library can
— a device has failed and the library cannot function (such as a failed
Note:
Clicking the library state in the status bar displays the Library
Health pop-up which you can use to troubleshoot the library (see
"Determine the Possible Cause of a Degraded or Failed Library State"
on page 7-2).
Monitoring the Library
7
near the top-right of the screen.
7
Monitoring the Library 7-1