Move The Library Rack - StorageTek SL150 Manual

The library automatically performs an audit whenever it powers up or whenever you
reinsert magazines.
Normally, host applications request audits. However, you can audit the library from
the remote interface, but you should avoid this, if possible, as it interrupts host
operations.
To manually initiate an audit:
From the remote interface, select Library in the left menu.
1.
From the Library drop-down menu
2.
Optionally, select Set the Library back Online ...
3.
To take the library offline, start the audit, and close the dialog, press OK.
4.
If you did not check the Set the Library back Online ... checkbox, remember to
5.
bring the library back online once you are ready.
Monitoring an Audit in Progress
The duration of an audit depends on the size of the library. For example, a 30-slot
library can take about 7 minutes to audit.
You can track the progress of the audit on the Library screen of the remote interface.
Grayed-out cartridge icons represent unaudited slots. As the audit progresses, audited
slots return to their normal appearance. Hovering over a slot shows the current
cartridge label information (see
information).

Move the Library Rack

Power the library off (see
1.
Secure the robot (see
2.
If the floor is uneven, remove all magazines from library as tape cartridges can
3.
shift and obstruct library robotics when the library is restarted.
a.
b.
Set the rack PDU circuit breakers to OFF and disconnect the PDU power cord(s)
4.
from the main circuit.
Label and disconnect any host connection or LAN cables.
5.
Raise any leveling pads until the casters are supporting the rack. Release any rack
6.
anti-tip device(s), and remove any wheel chocks.
Move the library to its new location. Reset the leveling pads.
7.
Reinstall the magazines.
8.
Reconnect power, host-connections, and local area network (LAN) cables.
9.
Unlock the robot.
10.
Power the library on.
11.
"Labeling Cartridges"
"Power Off the Library"
"Lock the Robot"
Unlock all magazines using the remote interface or local operator panel. Press
the Select All option on the Unlock Magazines dialog.
Remove all magazines.
, select Audit Library.
on page 6-3 for label
on page 9-2).
on page 9-3).
Servicing the Library 9-5
Move the Library Rack