Configure The Library Step 2 Of 6: Configure The Network Port 1 - StorageTek SL150 Manual

Configure the Library After Powering-on for the First Time
If an error message appears, click the keyboard button to access the keyboard
screen and clear the password field before you tap any key. Repeat previous steps
as necessary to correct the password entries.
Tap Next.
5.

Configure the Library Step 2 of 6: Configure the Network Port 1

Enter the host name:
1.
a.
b.
c.
d.
Option 1: Configure Network Port 1 with an IPv4 Address
2.
a.
2-32 StorageTek SL150 Modular Tape Library Guide
The six large dots in the password fields do not represent
Note:
the actual number of characters you entered for the password.
Tap the Keyboard button.
Clear the default value. Enter a new host name and then tap Next.
Valid host names contain the following characters: A through Z, a through z, 0
through 9, and the hyphen (-). A hyphen cannot be the first or last character in
the host name.
Neither the space nor the underscore (_) is supported.
Note:
Select an IP address type: IPv4 only or IPv4 and IPv6.
Tap Next.
Use the Configure IPv4 list to select either Static or DHCPv4.
If you select DHCPv4, for a successful startup, DHCPv4 must be running on
your network.
If you select Static, tap the keyboard button and then enter the following:
– Address — Clear the default value. Enter the IPv4 Address in the format
XXX.XXX.XXX.XXX and then tap Next.
Netmask —Clear the default value. Enter the IPv4 Netmask in the format
–
XXX.XXX.XXX.XXX and then tap Next.
– Gateway — Clear the default value. Enter the IPv4 Gateway value in the
format XXX.XXX.XXX.XXX and then tap Done.