Table of Contents
Advertisement
Optionally, select Set the Library back Online to automatically bring the library
5.
online after the test (the library goes offline to perform the self test)
Click OK to start the test.
6.
If you did not check the Set the Library back Online checkbox, remember to bring
7.
the library back online manually, once you are ready. See
and Offline"
Stopping a Self-test
To stop a test that is in progress, from the Library drop-down
current test. The test may take a few moments to stop. If the diagnostic cartridge was
not returned to its reserved cell at the end of the test, move the diagnostic cartridge
now (see
If the test fails, click Degraded to open a health table
Note:
identifying a failed or degraded component. See
Table to Diagnose the Issue"
on page 9-1.
"Move Tape Cartridges with the Remote Interface"
"Use the Health
on page 9-7 more information.
on page 6-11).
Run a Self-Test
"Place the Library Online
, select Stop the
Installing the Library 2-37
Advertisement
Table of Contents
