Install the Base Module
Mount the Base Module Task 1: Engage the Base Module with the Rail
Grasp the module along the sides and lift the back above the rack rails.
1.
Guide the module into the rack and set the rear side-tabs on the rack rails (see
2.
Figure
Push the module into the rack to engage the bottom and center side tabs.
3.
Push the module into the rack until the front side-tabs approach the front of the
4.
rack rails.
Lift the module up slightly, push it into the rack, and set the front tabs down on
5.
the rack rail.
Mount the Base Module Task 2: Remove the Cartridge Magazine with the Hex Key
Insert the hex key in the hole at the lower inside corner of the cartridge magazine.
1.
Align the hex key shaft parallel with the magazine face.
2.
Push the tool slowly into the hole to release the latch located behind the touch
3.
screen, and hold the hex key in place.
Pull the magazine a short distance out of the library.
4.
Remove the hex key and store it for future use.
5.
2-12 StorageTek SL150 Modular Tape Library Guide
The base module is heavy and requires two people to
Warning:
lift and install it.
Never lift the module by the front control panel or the tape
Note:
drive. Always lift the module from the side.
2–9).
If the module does not fit properly, remove it from the rack.
Note:
Adjust the rail spacing as necessary. Never bend the base module
side tabs.