Table of Contents
Advertisement
Electrostatic Discharge
Be aware of the precautions needed when handling parts. A discharge of static
electricity might damage static-sensitive devices which may reduce the life expectancy
of the product.
Electrostatic Discharge Prevention
Avoid hand contact by transporting and storing products in static-safe containers.
■
Keep electrostatic-sensitive parts in their containers until they arrive at static-free
■
work areas.
Place parts on a grounded surface before removing them from the container.
■
Avoid touching pins, leads, or circuitry.
■
Use proper grounding practices when touching a static-sensitive component or
■
assembly.
Grounding Methods to Prevent Electrostatic Discharge
Use a wrist strap connected by a ground cord to a grounded chassis.
■
Use conductive field service tools.
■
Use a portable field service kit with a folding static-dissipating work mat.
■
Prepare the Rack
Rack Requirements
Rack must contain four posts.
■
Front and rear service clearance must be at least 965 mm (38 inches).
■
Front of the rack must face the cool aisle and the rear face the warm aisle.
■
Rack must be level (left to right and front to back). The installed library must
■
remain level for proper operation.
Vertical rail spacing should be between 457 mm (18 in) and 902 mm (35.5 in.
■
Provide sufficient rack space to install the base module (3U) and any expansion
■
modules (2U each).
Rack Preparation
Position the power distribution unit (PDU) on the right side of the rack as viewed
■
from the rear of the rack (see
right side of the SL150 library. Refer to the rack and power distribution unit
documentation for instructions to install the PDU
To provide access during installation of a library module, remove the front door
■
from the rack.
If you do not have the suggested equipment for proper
Note:
grounding, arrange for an authorized reseller to install the part.
Figure
2–1). The power supply outlets are on the
Prepare the Rack
Installing the Library 2-3
Advertisement
Table of Contents
