Restore The Factory Default Configuration - StorageTek SL150 Manual

Troubleshoot the Library

Restore the Factory Default Configuration

This procedure requires two people. One person at the front of the library and one
1.
at the rear. A single person cannot reach both buttons simultaneously.
Find the locator buttons — front upper left and rear top center (see below)
2.
Push and release either one of the locator buttons.
3.
Once the locator buttons light, simultaneously push and hold both front and rear
4.
buttons for about 10 seconds until the lights rapidly flash.
When the lighted locator buttons start flashing rapidly, release both buttons. The
5.
library is now reset to defaults. It should power down and restart.
If the library does not power-on automatically, press the power button.
6.
9-10 StorageTek SL150 Modular Tape Library Guide
Resetting the library erases the existing configuration. You will
Note:
have to recreate the configuration from scratch, so do not use this
procedure on an operational library except as a last resort.
After 3-4 seconds, the lighted locator buttons flash slowly.
Note:
After 10 seconds, the locator buttons should start to flash rapidly.
If either Locate button is released before the fast flash rate,
Note:
the reset process terminates.