Table of Contents
Advertisement
Base Module (Module 1) Chassis Removal and Replacement
Extract the module from the rack.
3.
Replace the Base Module Chassis
Replace Base Task 1: Install the Base Module FRU
■
Replace Base Task 2: Install the Base Module CRUs and Expansion Modules
■
Replace Base Task 3: Reinstall Magazines and Dress the Cables
■
Replace Base Task 1: Install the Base Module FRU
Grasp the base module chassis by the sides and remove it from the shipping
1.
carton.
If there are no expansion modules for this library, install the floor in the base
2.
module (see
Mount the base module (see
3.
Replace Base Task 2: Install the Base Module CRUs and Expansion Modules
Reinstall the base module components.
1.
■
■
■
■
■
■
Reinstall the expansion modules (see
2.
page 10-15). Make sure to install the floor in the bottom module.
Re-cable the expansion modules. Connect the specific base module port to the
3.
controller card port of the associated expansion module. See
Task 1: Cable the Expansion Modules"
Replace Base Task 3: Reinstall Magazines and Dress the Cables
Install cartridge magazines in all modules (see
1.
Locking the Magazines and Auditing the
Align and dress the cables. Secure the cables in the hook and loop straps, if
2.
applicable.
10-18 StorageTek SL150 Modular Tape Library Guide
The base module weighs approximately 12.8 kg (28.3
Warning:
pounds) without magazines, tape drives, power supplies, or the
robot CRU. A best practice is to use two persons to lift the unit.
"Install the Floor in the Bottom Expansion
"Replace the Robot"
on page 10-12
"Replace the Drive Tray"
"Install a Drive Filler"
on page 10-4
"Replace the Power Supply"
"Install a Power Supply Filler"
"Replace the Front Control Panel"
"Mount the Base Module"
on page 10-3
on page 10-4
on page 10-5
on page 10-6
"Replace the Expansion FRU Chassis"
on page 2-27 for details.
"Load the Magazines Task 4:
Library").
Module").
on page 2-11).
on
"Cable the Library
Advertisement
Table of Contents
