Table of Contents
Advertisement
Return CRU Components to Oracle
Return CRU Components to Oracle
You should only replace a single CRU at a time. Keep the original CRU until the
correct CRU is identified as faulty.
Return the robot and tape drive tray CRUs to Oracle. Instructions should have been
provided regarding the process to return the specific CRU.
Dispose of all other CRUs or recycle them, as appropriate.
Lock the Robot for Reshipment within Rack
Use the following instructions if you are shipping the SL150 after installing it into a
rack.
Power Down the Library and Verify Robot Position
■
Install the Shipping Clip
■
Power Down the Library and Verify Robot Position
Power down the library with the "to prepare the robot for removal" option
1.
enabled (see
Lock the robot (see
2.
Remove the right cartridge magazine from the base module (see
3.
Module Task 2: Remove the Cartridge Magazine with the Hex Key"
necessary).
Make sure the robot has positioned the hand against the ceiling and front face of
4.
the library (see image below).
Install the Shipping Clip
Verify the robot is in position (see
1.
Position).
Grasp the shipping clip and reach through the cartridge magazine opening.
2.
10-20 StorageTek SL150 Modular Tape Library Guide
Improper installation of the lock could cause catastrophic
Caution:
failure during shipment.
"Controlled Power-Down from the Interface"
"Lock the Robot"
on page 9-3).
Power Down the Library and Verify Robot
on page 9-2).
"Mount the Base
on page 2-12 if
Advertisement
Table of Contents
