Table of Contents
Advertisement
Figure 2–3 Back Rail Position
Illustration Legend:
1 - Pins
Figure 2–4 Back Rails Installed
Locate where you will mount the base module within the rack, allowing space for
1.
expansion modules (use the rail installation template as necessary).
The rails must reside with a single U boundary. Do not mount the block with the
pins straddling a U boundary.
From the accessory kit, select the appropriate attachment hardware for your rack,
2.
and set the other hardware aside.
A rack with square mounting holes uses the clip nuts and
Note:
10-32 X 5/8 screws (the M5 and M6 screws are only used in
threaded hole racks).
Install the Base Module
Installing the Library 2-7
Advertisement
Table of Contents
