For T9x40 drives:
1. Be sure the transport is not in use by the system.
Note: If you press the
2. Press the
•
•
9206
UNLOAD
write the remaining data before the cartridge tape unloads. If the operator
panel displays the "UnWr xxxx" (Unwritten Data) message (where xxx =
the fault symptom code), the attempt failed and some data remains unwritten
on the tape. Refer to the T9940 Tape Drive Operator's Guide, PN 95989, or the
T9840 Tape Drive User's Reference Manual, PN 95739, for this situation.
switch. One of the following conditions occurs:
UNLOAD
After the tape rewinds, the cartridge tape ejects from the drive. Remove the
cartridge from the drive.
The cartridge tape fails to eject after the tape rewinds. Refer to the T9840 Tape
Drive User's Reference Manual or the T9940 Tape Drive Operator's Guide for this
situation.
Eleventh Edition
switch during a write operation, the drive tries to
LSM Manual Mode
3-57