Configure Simple Network Management Protocol (SNMP)
Table 7–1 (Cont.) SNMP Trap Levels
Trap Level Description
3
4
11
13
14
15
21
25
27
41
45
61
63
65
100
102
Enable or Disable SNMP
From the remote interface, select SNMP in the left menu.
1.
Click the SNMP is Enabled/Disabled
2.
Select either Enable SNMP or Disable SNMP.
3.
Click OK to confirm the change.
4.
Configure an SNMP User
SNMP users can access the library's SNMP agent. You can add, modify, or delete an
SNMP user:
From the remote interface, select SNMP in the left menu.
1.
Select the SNMP Users tab.
2.
Click Add SNMP User
3.
Delete SNMP User
■
Configure an SNMP Trap Recipient
An SNMP trap recipient is a network management station that you designate to
receive notifications sent by the SNMP agent on the library. You can add up to six trap
recipients. You can add, modify, or delete an SNMP trap recipient:
From the remote interface, select SNMP in the left menu.
1.
Click the SNMP Trap Recipients tab.
2.
7-4 StorageTek SL150 Modular Tape Library Guide
info log entry
configuration
agent start
test
heartbeat A (2.5 minute period)
heartbeat B (24 hour period)
Library Status Good
Library Status Check
Environmental Hardware Check
Drive Status Good
Drive Status Check
CAP (mailslot) Status Good
CAP (mailslot) Status Open
CAP (mailslot) Status Check
Proprietary
Proprietary
, or select a user and then click Edit SNMP User
.
See
"SNMP Versions"
on page 7-3 for the required version information.
drop-down.
or