Install the Expansion Module
Prepare the Expansion Module by Removing the Cartridge Magazines
■
Mount the Expansion Module
■
Install the Rear Rails for the Expansion Module
■
Secure the Expansion Module to the Front Rack Stile
■
Replace the Cartridge Magazines
■
Tools Required
#2 Phillips screwdriver.
Figure 2–11 Expansion Module
Illustration Legend:
1 - Alignment Tab
2 - Flanges
Unpack the Expansion Module Accessory Kit
Each expansion module accessory kit should contain the following:
Back rails
■
10–32 clip nuts (used in racks with square holes)
■
Assorted screws:
■
–
–
–
Expansion interconnect cable with USB Type A connectors
■
Label set (Module 2 through Module 10)
■
Hook and loop strap
■
Pop-in rivet
■
Hex key
■
2-14 StorageTek SL150 Modular Tape Library Guide
10–32 X 5/8 screws (used with clip nuts and racks with 10-32 threaded holes)
M5 0.8 X 16 mm screws (used with M5 threaded hole racks)
M6 16 mm screws (used with M6 threaded hole racks)