Configuring The Library - StorageTek SL150 Manual

This this section covers how to change the library configuration at any time after the
initial installation configuration. For initial installation configuration, see
the Library After Powering-on for the First Time"
Set the Time, Network Address, Library Settings, and Encryption
■
Update Library and Drive Firmware
■
Manage the Library's SSL/TLS Certificate for HTTPS
■
Set the Time, Network Address, Library Settings, and Encryption
Use the configuration wizard to change the library time, network parameters, library
settings (such as auto cleaning, mailslots, partitioning, and so on), and encryption.
"Run the Configuration Wizard"
■
"Configure the Network Interfaces"
■
"Set the Library Date and Time"
■
"Configure Library Settings"
■
"Partition the Library"
■
"Configure Library Managed Encryption (LME)"
■
"Review and Apply Configuration Changes"
■
Run the Configuration Wizard
From the remote interface, select Configuration in the left menu.
1.
Click Configure
2.
Within the Configuration Wizard, select each configuration task that you need to
3.
perform, and then click Next. Proceed to the relevant sections:
■
■
■
■
on page 4-5
.
Configure the Network Interfaces
Set the Library Date and Time
Configure Library Settings
Configure Library Managed Encryption (LME)
You cannot configure the network interfaces and encryption
Note:
simultaneously.

Configuring the Library

4
on page 2-30.
on page 4-1
on page 4-2
on page 4-3
on page 4-3
on page 4-6
on page 4-7
4
"Configure
Configuring the Library 4-1