Replace Expansion Task 3: Install The Remaining Expansion Modules; Replace Expansion Task 4: Finishing Touches; Base Module (Module 1) Chassis Removal And Replacement - StorageTek SL150 Manual

Base Module (Module 1) Chassis Removal and Replacement

Secure the module (see
6.
page 2-22).
Replace Expansion Task 2: Install CRUs, Fillers, and Magazines in Replaced Module
Cables and cords are connected as part of CRU installation.
Install the module controller (see
1.
Install the tape drive assembly (see
2.
Install the tape drive filler (see
3.
Install the power supply (see
4.
Install the power supply filler (see
5.
Insert the cartridge magazines.
6.

Replace Expansion Task 3: Install the Remaining Expansion Modules

Locate the next expansion module for installation (refer to the module number
1.
label on the back of the module).
Repeat the installation tasks until all expansion modules and CRUs are installed
2.
(refer to and ).
Make sure you have installed the floor in the bottom module (see
3.
in the Bottom Expansion Module"

Replace Expansion Task 4: Finishing Touches

Secure the hook and loop strap to the replaced expansion module (close the
1.
plunger of the rivet).
Align, dress, and secure cables in the hook and loop straps.
2.
Follow the power on procedures (see
3.
Base Module (Module 1) Chassis Removal and Replacement
You must transfer the cartridge magazines, front control panel, tape drive(s), tape
drive filler, power supply, power supply filler, and the robot from the defective base
module to the FRU.
Remove the Base Module Chassis
■
Replace the Base Module Chassis
■
10-16 StorageTek SL150 Modular Tape Library Guide
"Secure the Expansion Module to the Front Rack Stile"
When the library capacity is more than 300 cartridges, you will
Tip:
not connect the output port for Module 6 through Module 10 now.
You connect the port when installing Module 11 through Module 15.
The base module is a field-replaceable unit (FRU) and must be
Note:
serviced by an Oracle service person.
"Replace the Module
"Replace the Drive
"Install a Drive Filler").
"Replace the Power Supply").
"Install a Power Supply
on page 2-18).
"Validate the Component
on
Controller").
Tray").
Filler").
"Install the Floor
Installation").