Front Control Panel Removal and Replacement
1 - Tabs
2 - Jack
3 - Latches
Remove the Front Control Panel
Power down the library (see
1.
Remove both cartridge magazines from the base module (see
2.
Task 1: Unlock and Remove the Magazines"
Press the latch inside each magazine bay inner wall and pull the bottom edge of the
3.
panel away from the module until the panel unlatches (see image below).
Free the tabs on the top edge of the panel from the module.
4.
Rotate the top edge of the panel away from the top of the module about 90 degrees
5.
and hold the panel in this position with one hand.
Disconnect the ribbon cable plug from the jack located on the circuit card.
6.
Set the panel CRU on the anti-static mat.
7.
Replace the Front Control Panel
10-6 StorageTek SL150 Modular Tape Library Guide
ESD damage. Do not touch any exposed electronic
Caution:
components, cables, or contacts.
"Power Off the Library"
on page 6-7).
on page 9-2).
"Load the Magazines