Table of Contents
Advertisement
Restart the Library
Lock the Thumbscrew-type Robot Lock (older version)
Loosen the captive thumbscrew on the lock assembly. Pull the lock straight out
1.
until the long tab comes out of the slot at right.
Rotate the lock assembly counterclockwise 180 degrees, and slide the long tab into
2.
the slot at left.
Verify a red locked padlock icon is visible in the small window.
Secure the lock assembly by tightening the captive screw. The robot is now locked.
3.
Restart the Library
Click the power button
1.
Restart Library.
If the library has been operating normally and if its contents have not changed,
2.
select Bypass audit for a faster restart ...
The option is not available if magazines are open or if the library has been in the
Inoperative state. For more information, see
Restarting the Library Following a Power Outage
If a power outage occurs, the library returns to its last power state once power is
restored. When power is restored, the library powers up and runs just long enough to
check its previous power state. If the library was ON before the outage, it will be ON
afterward. If it was OFF, the library powers itself OFF after a few seconds.
Restarting a library that was off prior to a power interruption is like powering on any
other library that is off. See
Audit the Library
During an audit the robot checks each cartridge slot, recording cartridge labels and
locations to create a tape catalog. The library must audit whenever tapes are manually
moved (meaning moved with human intervention) so that it can update the catalog.
9-4 StorageTek SL150 Modular Tape Library Guide
in the upper-left of the user interface, and then select
"Audit the Library"
"Power On the Library"
on page 9-4.
on page 9-2.
Advertisement
Table of Contents
