Table of Contents
Advertisement
Click Add Trap Recipient
3.
Recipient
■
■
■
Send a Test Trap
To verify the configuration, you can sent a test trap (level 13) to all trap recipients.
From the remote interface, select SNMP in the left menu.
1.
Click the SNMP Trap Recipients tab.
2.
Click Send a Test Trap
3.
the list. Make sure you have enabled SNMP.
Download the Management Information Base (MIB)
From the remote interface, select SNMP in the left navigation menu.
1.
Click Download Mib
2.
Save the file or view it in a text editor.
3.
Enable or Disable the Service Delivery Platform (SDP2)
From the remote interface, select SNMP in the left menu.
1.
Click the SDP2 is Enabled/Disabled
2.
Select either Enable SDP2 or Disable SDP2.
3.
To enable SDP2:
4.
a.
b.
c.
Configure Email Notifications
You can configure the library to send automatic email alerts to specified addresses
whenever the library changes state (from online to offline, for example) and/or
whenever library health is degraded.
"Enable or Disable Email Notifications"
■
"Configure Email Recipients"
■
"Send a Test Email Alert"
■
or Delete Trap Recipient
Host Address — IP address of the management host that will receive the traps
Trap Level — Comma-delimited list of the Trap Levels to send to this
management station. For a list of valid entries, see
Version — The SNMP version. See
additional required information.
. If the icon is grayed-out, try clicking on a recipient in
.
Enable SNMP (see
"Enable or Disable SNMP"
SDP2 without enabling SNMP. But you cannot enable SDP2 until you enable
SNMP.
Configure an SNMP trap recipient to receive trap levels: 13,14,15,102 (see
"Configure an SNMP Trap Recipient"
configure at least one SNMP trap recipient to receive the specified traps.
The button should now read SDP2 is Enabled (Configured). If not, verify you
have enabled SNMP and have a recipient configured with the trap levels:
13,14,15,102.
on page 7-6
, or select a recipient and then click Edit Trap
.
"SNMP Versions"
drop-down.
on page 7-4). You can configure
on page 7-4). To use SDP2, you must
on page 7-6
on page 7-6
Configure Email Notifications
"SNMP Traps"
on page 7-3.
on page 7-3 for details on
Monitoring the Library 7-5
Advertisement
Table of Contents
