Table of Contents
Advertisement
Install Power Supplies
Install power supplies in the 9738 between the drive slots and the electronics
module. Use the instructions below to attach a power supply to the 9738:
Note: Ensure the power supply switch is off.
1. Open the rear cover of the library.
2. Slide the power supply into the library.
a. Make sure to seat the metal tab into the slot at the rear of the chamber (see figure).
b. Place the power supply for Drive 0 in the lower left (see figure).
2
1
3. Tighten the mounting screw.
4. Repeat Steps 2 and 3 for all remaining drive power supplies.
Note: Place the power supply for Drive 1 in the lower right, and the power supply for
Drive 2 in the upper left.
95741
1. Metal tab
2. Mounting screw
E53249
Sixth Edition
9738 Library Attachment
3-11
Advertisement
Table of Contents
