Support the bottom of the magazine with your other hand during removal.
6.
Pull the magazine out of the module, and set it aside.
7.
Mount the Base Module Task 3: Remove the Cable Clip
Remove both cartridge magazines from the base module.
1.
Locate the tag in the right cartridge magazine opening.
2.
Grasp the ring and pull down.
3.
Discard the cable clip unless you intend to reship the library after rack installation.
4.
Figure 2–10 Cable Clip Removal
Mount the Base Module Task 4: Secure the Base Module to the Rack
Insert a screw through the bottom hole of the base module and thread it a few full
1.
turns.
Insert a screw into the bottom hole on the other side of the module and thread it a
2.
few full turns.
Fully tighten both retaining screws.
3.
Replace the cartridge magazines if you are not installing expansion modules.
4.
Install the Expansion Module
Installing the Expansion Module involves the following tasks:
Unpack the Expansion Module Accessory Kit
■
Remove the Library Floor
■
Install Clip Nuts for the Expansion Module (for square hole racks only)
■
Note:
Use a 10-32, M5, or M6 screw depending on your rack
hardware. Use the 10-32 screw when the rack has square mounting
holes (the screw mates with the clip nut).
Left and right magazines are unique. Orient the magazine
Note:
so the cartridge openings face the Front Control Panel.
Do not put cartridges in the magazine slots.
Install the Expansion Module
Installing the Library 2-13